ANYCUBIC Delta Kossel Plus

[microcontrollorepic]

ciao,
questa è la risposta del fabbricante:

hello andrea

thanks for buying our 3D Printer.
the problem you mentioned regards leveling adjustment.
As the height of platform center to surroundings is inconsistent, which leads printed pieces will be too large or too small.

to solve this problem,pls go to our official website (Shenzhen Anycubic Technology Co.,Ltd) to refresh the firmware for Kossel Plus or you could directly check the firmware in SD card.

then decrease the value of 'DELTA_DIAGONAL_ROD' with 1~3
// Center-to-center distance of the holes in the diagonal push rods.
#define DELTA_DIAGONAL_ROD 271.5 // mm

other problems,pls feel free to contact.
regards
jutta

il firmware del link non lo carica mi da un errore.

modificando i valori del DELTA_DIAGONAL_ROD non cambia nulla.....

Flavio