Cut2G: Da GMFC a g-code a 4 assi

[domenicopresta]

ho creato un'ala semplice in gmfc ...
l'ho salvata ...

ma cut2G mi combina solo questo :

++++++++++++++++++
%% G-Code prepared by cut2G, version 1.3
%% copyright G Sokoll 2012

%% SET LENGTH UNITS
%% G20: INCHES
%% G21: MILLIMETERS
G21

%% SET CUTTER COMPENSATION
%% G40: OFF
%% G41: ON LEFT
%% G42: ON RIGHT
G40

%% SET TOOL LENGTH OFFSET
%% G43: INDEX IN TOOL TABLE
%% G49: NO OFFSET
G49

%% SET PATH CONTROL MODE
%% G61: EXACT STOP
%% G64: CONSTANT VELOCITY
G64

%% SET DISTANCE MODE
%% G90: ABSOLUTE
%% G91: INCREMENTAL
G90

%% SET FEED RATE MODE:
%% G93: INVERSE TIME MODE (MOVES PER MINUTE)
%% G94: UNITS PER MINUTE (PER SECOND ???)
%% G95: UNITS PER REV
G94

%% Axes Naming convention:
%% - Left hand axes = X, Y
%% - Right hand axes = A, B

%% Turn off wire heat
M5
%% End of file. Bye.




++++++++++++++++++++++

dov'e' che sbaglio ?